Installation Guides
Step-by-step instructions for setting up your AquaSense
Before You Start
Timer Kit Installation
20-30 minsEasy- 1Unbox and verify all components
- 2Mount the controller near your pump
- 3Connect relay wires to pump switch
- 4Plug in power adapter (USB-C)
- 5Download app and connect via Bluetooth
- 6Configure timer settings
Watch video guide
Basic Kit Installation
30-45 minsEasy- 1Complete Timer Kit installation first
- 2Mount sensor bracket on tank lid
- 3Attach ultrasonic probe facing down
- 4Run sensor cable to controller
- 5Connect sensor cable to controller port
- 6Calibrate tank dimensions in app
Watch video guide
Smart Kit Installation
45-60 minsMedium- 1Complete Basic Kit installation
- 2Identify your pump power cable
- 3Clamp current sensor around pump wire
- 4Connect current sensor to controller
- 5Enable 'Smart Detection' in app
- 6Test by running pump manually
Watch video guide
Downloadable Resources
Installation Manual (PDF)
2.4 MB
Wiring Diagram
856 KB
Tank Calibration Guide
1.1 MB
Device Provisioning Flow
Standard Setup Sequence
- 1Power on the device
- 2Open the Nivoryx app and scan for BLE devices
- 3Connect to your device via Bluetooth
- 4Configure WiFi (SSID and password)
- 5Device connects to WiFi automatically
- 6Cloud registration completes (automatic)
- 7MQTT credentials provisioned (automatic)
- 8Assign and configure your apps
- 9Device ready for operation
Multi-Device Setup (Auto-Fill System)
- 1Power on the coordinator first
- 2Wait for Zigbee network formation (~30 seconds)
- 3Open the network for device joining (via app or BLE command)
- 4Power on sensor devices — they join automatically
- 5Power on actuator device — joins automatically
- 6Configure via app (tank dimensions, thresholds, motor settings)
- 7System ready for auto-fill operation
Installation FAQs
Can I install it myself without an electrician?
Yes! Timer Kit and Basic Kit are fully DIY. For Smart Kit and above, we recommend basic electrical knowledge or help from a local electrician for the current sensor installation.
What tools do I need?
Screwdriver, measuring tape, and a phone to scan QR code. That's it! All mounting hardware is included.
Where should I mount the controller?
Mount it near your pump starter, protected from rain and direct sunlight. Indoor locations are ideal.
What if my tank lid doesn't have a hole?
You can drill a small hole (2cm) or use our surface-mount bracket that sits on top of the tank lid.
How do I run the cable from tank to controller?
Use existing conduits if available. Otherwise, use cable clips along the wall. We include 5m cable; extensions available.